FREE Shipping For All USA Orders Over $50. Code FREESHIPPING At Checkout!

FastReligion CVT Shifter Knob
FastReligion CVT Shifter Knob
FastReligion CVT Shifter Knob
FastReligion CVT Shifter Knob
FastReligion CVT Shifter Knob
FastReligion CVT Shifter Knob

FastReligion CVT Shifter Knob

Regular price $29.99 Sale

Factory shifter looking a little tired?

Want a sportier look?

In just a few minutes you can change the look of your interior completely with the new FastReligion upgraded Shifter Knob.

This was specifically designed for the CVT Juke/Sentra shifter.

The large shift lock button located at the top is easy to operate and gives a more sporty feel.

Available in three designs:

Horizontal Grip

Vertical Grip

Knurled Grip

 

 

Install is a breeze and only requires 2 tools!

A flat-head screw driver and an alan key.

Steps to install:

  1. Remove the factory lower shift knob using the flat head screw driver.
  2. Locate the small metal "U" shaped clip at the base of the knob, use the screw driver to remove it.
  3. Lift the factory knob off the car.
  4. Take the new knob with center button installed and slide it over the shifter shaft.
  5. Lower the assembly until the button is flush with the top of the new knob.
  6. Firmly press the button down so that it seat itself onto the shift release. NOTE: the button may still move freely after this, IF you want the button to not move, a small dab of superglue can be put inside the lower hole on the button, just be sure NOT to get glue onto any other part of the shift knob or shifter assembly.
  7. With the new knob in position, rotate the knob so the set screws are on the flat surface of the shifter rod, this is the left and right sides of the rod.
  8. Tighten the set screws using the alan key. DO NOT over tighten, you can strip the holes, it does not take a lot of pressure to hold the knob in place.